How to Fix Frigidaire Oven Error Codes

Whether you have a refrigerator, range or oven, you are sure to come across the different error codes that your device may be giving. In this article, we will discuss what each code means and how to solve them. The first error code is F1 for overheating and indicates the need for replacement of the electronic oven control. To fix this error, you need to pull the oven away from the wall and remove the six screws holding the upper back panel.

If you see the F011 error, the probe circuit is open. Check the resistance at the sensor plug against the resistance chart and replace the probe if it does not match. Once you’ve done this, restart the oven and the problem should be solved. Alternatively, the door motor mechanism could be failing and the controller will not see it spinning. If you can’t find the problem at this point, you can try to replace the door motor.

If your oven won’t turn on, try a different appliance or power source to determine the cause of the problem. First, check the electrical outlet. If it doesn’t give out enough voltage, you might have an overheating problem. This can cause the thermal fuse to trip. If this is the case, you may need to replace the thermal fuse. In most cases, the repair of this error code will be simple and straightforward.

If the error code is for F10, check the temperature sensor. If the oven temperature sensor is not working, it may be the cause of the error. Identifying the temperature sensor is as simple as checking the resistance of the wires on the EOC. Make sure that the resistance between the wires is at least 1100 Ohms. Otherwise, you will have to replace the oven. If this does not work, you may need to replace the entire oven.

The first error code is F3, which means the electronic oven control or EOC is failing. The easiest way to troubleshoot this is to access the rear of the EOC and check the temperature sensor. The two violet wires connect the EOC and temperature sensor, and if they are shorted, it means the unit is overheating. To clear this error, you can try restarting the oven and then recheck the codes.

If F1 is not the issue, the next step would be to check the door lock mechanism. Make sure that the door lock mechanism is working properly and that the wiring is good. If these steps do not solve the issue, you can try replacing the relay board. Moreover, you should check the door lock mechanism. If all else fails, replace the door switch. If it does not, replace the latch motor assembly. If the problem persists, you can also replace the door lock mechanism.

To test the temperature setting of your Frigidaire oven, press the “BAKE” button for six seconds until a 0 appears on the display. After that, retest your favorite recipes and try again. If the temperature change worked, the oven should be baking correctly. This is a simple procedure. To check the temperature, you can also press the “TEST” button, which should be displayed on the display.