How to Fix the E08 Error on Lazy Spa
Having trouble with the E08 error on your lazy spa? There are a couple of common fixes that can resolve this issue. First, try to find the cause of the error. Often, the problem stems from the heater pump. Sometimes, this issue is due to faulty wiring or a faulty switch. To resolve this issue, you need to check the wires and replace any faulty parts. Next, you should try to switch on the pump by using the On/Off button on the display. Press and hold the button for ten seconds. If the problem persists, then the pump may need to be replaced.
Sometimes, the error may be caused by the digital temperature sensor. It may have become disconnected or damaged. In either case, you should try to reset the spa and real time clock. If this does not solve the issue, contact the spa pool supplier to find a solution. You can also try to reset the spa using the manual. The manual will provide detailed instructions for doing so. If all else fails, it’s best to consult with a professional.
The error code E08 is caused by a sensor in the Lay Z Spa that senses an unsafe temperature. It shuts off the heater when the water gets too hot. To avoid this problem, you must use appropriate water chemicals. Also, check the pH level of your water. If the pH level is too high, you need to lower the temperature of the water in the spa. It’s important to use the right chemicals when using hot water in a hot tub.
If you still have trouble with the E08 error on your Lay-Z-Spa, try to fix it as soon as possible. A few simple tips can help you resolve this problem and avoid costly repairs in the future. The first step is to check the temperature of the water in your Lay-Z-Spa. If it’s higher than 40degC or 104degF, the water temperature is too high. To fix this issue, you need to unplug the pump. You should then press the thermal reset button for five seconds. After that, you can turn the heater back on and test the pump.
Once the temperature is low, you should check the filters. The E02 error code is caused by a dirty filter. If you can find the problem in the filters, then you can clean them. If you can’t find the dirty filter, remove the filter cartridge and clean it. Lastly, run a luke warm water cycle to clean out the filter cartridge. If these steps fail, you can try resetting the spa.
If you see an E08 error on your Lay-Z-Spa, the air jet pump is likely to be causing the problem. If it’s too cold, it will not operate at all. You’ll have to bring the spa indoors for it to warm up. If you’re unable to bring the tub inside, you can try reverse flushing the water and filter. Remember to use extreme caution when doing this to avoid damaging the tub.
