How to Troubleshoot Maytag Washer Error Codes

You might have a Maytag washer that keeps displaying error codes. These errors are often caused by a problem with the main water supply. If you can’t fix the problem yourself, you should take it to a Maytag service center. Technicians can help you replace the heating element and fix the problem. You may also have to replace the filter screens, if the problem is with the water line. However, there are some things you can do to troubleshoot this problem.

The first step is to check the lid of your washer. The lid may be stuck open after a few cycles. If the door has been left open for more than five seconds, it may be a problem with the door switch. If the door is locked, the washer will attempt to lock the door six times before it starts the cycle. If the lid doesn’t unlock, the motor will stop working and drain the water. The next step is to try to remove the obstruction that causes the Maytag washer to display this error code.

This error code means that the machine is not responding to commands. It indicates that there is a problem with the serial communication. You may need to replace the CCU or MCU. Hopefully, this will fix the problem. If the issue persists, you should contact a Maytag service center to get your washer repaired. If you can’t fix it yourself, the manufacturer’s warranty covers it. You should also be able to find a replacement part at your local home improvement store.

The first step is to check the inlet hoses for obstructions. If your door is open, it may be an indication that there is too much suds in the machine. Make sure that it’s properly closed. In addition, make sure to check the water level inside the washer. You might notice a pausing or tumbling cycle. If you still can’t resolve the issue, you can perform a manual check by pressing the power button and holding it for five seconds.

The next step is to determine the cause of the error code. Some error codes are the result of similar situations. Sometimes, you can fix minor issues by deciphering the error code. In some cases, you might need to contact a professional to fix the unit. But if it’s a more serious issue, you should contact a technician to get the problem fixed. If the problem persists, the best course of action may be to replace the machine.

If you see the error code 904, the water level sensor may be out of range. If it is, turn off the water supply and clean the filters in the hot and cold water inlet valves. Another possible cause is that the detergent drawer is stuck. You can clean it to prevent this error code from appearing again. If the sensor is working properly, the washing machine should start working normally. The error may also indicate a problem with the water valve.