Whirlpool Cabrio Washer Error Codes

You may find that your Whirlpool Cabrio washer has error codes and does not spin. To resolve this problem, you must first unplug your machine from the wall and turn off the water lines to the washer. Mark the hot and cold hoses to make them easier to identify. You may also need to remove the drain line from the wall to access the rotor unit. Lay your washer on a towel to catch any water that is leaking out of the machine. Then, unscrew the protective shield from the machine and place it on the floor.

The cause of Whirlpool cabrio washer error codes varies depending on the model. The first is a failure in the main control board. If this is the cause, you should replace it. If the problem persists, you can try replacing the main electronic control board. To replace the main electronic control board, first unplug the washing machine. You will need to move it away from the wall to access the back panel.

In addition to the underlying cause, other common Whirlpool Cabrio washer error codes include a lid left open, hot and cold hoses reversed, internal Appliance Control failure, and water level sensor failure. Troubleshooting steps are provided for each error code. Troubleshooting for the problems caused by a specific error code depends on whether you have a problem with the primary control or the motor.

If you are unable to identify the cause of the F51 Whirlpool Cabrio washer error code, you may have to replace the main control board. The process of replacing the central module will fix the problem and allow the washer to work properly again. Afterwards, you need to connect the water supply to the washing machine and reassemble it. You should run the test to verify the operation of the machine.

F2 is another common error code in the Whirlpool Cabrio washer. The code indicates a problem with the door lock assembly. If the door lock assembly is not working properly, the problem lies with the user interface. If the user interface board is malfunctioning, a replacement will need to be made. A few other Whirlpool Cabrio error codes are listed below. These codes are helpful for troubleshooting the problem and ensuring that your machine continues to run smoothly.

F03/E1 is the most common error code in a Whirlpool cabrio washing machine. If you have this code, you can easily fix it yourself. It is very simple to remove the code by following the steps below. Firstly, turn off the power source at the wall. Next, you should try to reconnect it again. If all else fails, you can contact a technician or repairman to diagnose the problem.