What are LTO error codes and what can they mean? Here’s a quick guide. Error 6 means the head has failed. It will appear midway through a backup. You can purchase replacement drives and heads from Hazell Computers to resolve the problem. Then, simply follow the steps below to prevent the error from reoccurring. If you keep running into these codes, contact your manufacturer for help.
First, determine the type of failure. You can diagnose the type of error by examining the drive’s health check and LTO logs. If the test fails, you can either replace the media or try a different method. If this does not resolve the problem, your next step is to format the tape. You can perform the procedure by downloading the diagnostic utility from the manufacturer’s website. If all of these steps fail, you may need to replace the LTO drive.
If your tape drive fails to detect an error, try removing and replacing the cartridge. In some cases, the problem can be resolved by ensuring that the correct voltages are applied to the drives. In more serious cases, you may need to replace the drive. The first step in determining the cause of this error is to power off the tape drive. Secondly, you can try to restart the operation that produced the error. If you don’t see the error, you may need to update the firmware of the tape drive. In that case, you must send the dump to the IBM Support Center.
LTO error codes are typically caused by a few different things. One example is the drive not being able to process a certain type of data. If you have a Sense Data or fiber AL-PA conflict, then the drive may be incompatible with the type of media. In some cases, the error may be related to an issue with the encryption key. If you cannot read or write data from an encrypted tape, you may have to perform a repair.